# BQ2407x Li-ion charger: 1.5 A with power path, 28 V input

> A single-cell lithium charger with power-path management so the robot runs while charging: input rating, current, USB limits and variants.

Canonical: https://roboticsengineering.in/components/bq2407x-lipo-charger/ | Published: 2026-11-03 | Updated: 2026-11-03

**The BQ2407x family (BQ24072 to BQ24079) are standalone single-cell lithium battery chargers with a 28 V input rating and overvoltage protection, charge current up to 1.5 A, and a power path that runs the robot while the battery charges.** The power path means the load is supplied from the input first, so a half-charged battery is not cycled while the robot is plugged in. Figures are from the Texas Instruments BQ2407x datasheet SLUS810N.

## Key specifications

| Cells | 1 |
| --- | --- |
| Input rating | 28 V with OVP |
| Charge current | up to 1.5 A |
| USB limits | 100 / 500 mA |
| Power path | DPPM |
| Package | VQFN-16 |

## What the datasheet promises

| Item | Datasheet value |
| --- | --- |
| Cell count | 1-cell linear charger |
| Input rating | 28 V, with overvoltage protection |
| Charge current | Up to 1.5 A, with a current-monitoring output (ISET) |
| Input current limit | Programmable up to 1.5 A for wall adapters; selectable 100 mA and 500 mA for USB |
| USB compliance | 100 mA maximum limit ensures USB-IF compliance |
| Power path | Dynamic power-path management powers the system while independently charging the battery |
| Source protection | Input dynamic power management protects against poor USB sources |
| Safety | Programmable pre-charge and fast-charge safety timers |
| Variants | System output tracks battery (BQ24072); programmable termination current (BQ24074); battery disconnect via SYSOFF (BQ24075, BQ24079) |
| Package | VQFN-16 |

It is a linear charger, so it burns the difference between the input and the battery voltage as heat. Charging a single cell at 1.5 A from a 5 V supply is workable; from a higher input the chip will reach thermal limits sooner.

## Using it on a robot

- Set the charge current with the resistor on ISET to the cell’s rating; do not exceed what the cell allows.
- Use a protected cell, and read the chosen variant’s charge voltage in the datasheet before use.
- Charge only with a supervised charger designed for lithium cells, and never leave a damaged pack charging.
- For the downstream rail, a boost or buck-boost converter such as the [TPS63020](https://roboticsengineering.in/components/tps63020-buck-boost-converter/) holds a steady voltage as the cell discharges.
- For a cell pack in a robot see the [18650 battery pack](https://roboticsengineering.in/components/18650-battery-pack/) guide.

## Sources and further reading

- [Texas Instruments BQ2407x datasheet (SLUS810N)](https://www.ti.com/lit/ds/symlink/bq24074.pdf) — the input rating, charge current, power path and variant differences above.

Last reviewed: November 2026. Limits are from the Texas Instruments datasheet; charger boards vary. No price is quoted because it has not been checked.
