# DRV8313 driver: three half-bridges for BLDC motors, 8 to 60 V

> A triple half-H-bridge driver for small three-phase brushless motors and gimbals: supply range, current, comparator and protection features.

Canonical: https://roboticsengineering.in/components/drv8313-three-phase-driver/ | Published: 2026-11-03 | Updated: 2026-11-03

**The DRV8313 is a triple half-H-bridge driver with 2.5 A peak current and an 8 to 60 V supply, designed to drive a three-phase brushless DC motor and also able to run solenoids or brushed motors.** It suits small gimbal-style BLDC motors, with the controller supplying the commutation. Figures are from the Texas Instruments DRV8313 datasheet SLVSBA5D.

## Key specifications

| Supply | 8–60 V |
| --- | --- |
| Peak current | 2.5 A per half-bridge |
| Bridges | 3 half-H |
| Extras | 3.3 V 10 mA LDO, current-limit comparator |
| Packages | HTSSOP-28, VQFN-36 |

## What the datasheet promises

| Item | Datasheet value |
| --- | --- |
| Supply voltage | 8 to 60 V |
| Output stage | Three N-channel half-H-bridges with independent control |
| Peak current | 2.5 A |
| Current sensing | Each half-bridge has its own ground pin for independent external sensing |
| Comparator | Uncommitted comparator for current limit or other functions |
| Built-in regulator | 3.3 V, 10 mA LDO |
| Modes | Sleep mode for standby |
| Protection | Undervoltage, charge pump fault, overcurrent, short circuit and overtemperature, with an nFAULT pin |
| Packages | HTSSOP-28 PowerPAD and VQFN-36 |
| Applications listed | Camera gimbals, HVAC motors, office automation, factory automation and robotics |

The chip only switches the three phases; the controller must decide which phase to drive and when, using a sensorless or sensor-based scheme. That commutation code is the hard part, not the driver wiring.

## Using it on a robot

- Use it with a microcontroller that has three PWM outputs and, for field-oriented control, a way to measure phase current.
- Connect each phase’s sense resistor to its own ground pin if you want per-phase current measurement.
- Use the nFAULT output to stop the motor on a short or overcurrent.
- For a brushed motor instead, a full H-bridge such as the [DRV8874](https://roboticsengineering.in/components/drv8874-motor-driver/) is simpler.

## Sources and further reading

- [Texas Instruments DRV8313 datasheet (SLVSBA5D)](https://www.ti.com/lit/ds/symlink/drv8313.pdf) — supply, current, half-bridges, comparator, regulator and protection above.

Last reviewed: November 2026. Limits are from the Texas Instruments datasheet; breakout boards and modules vary. No price is quoted because it has not been checked.
