# NE555 timer: 4.5 to 16 V and 200 mA output

> The classic timer chip: supply range, output current, trigger and threshold levels, and where a 555 still helps in a robot.

Canonical: https://roboticsengineering.in/components/ne555-timer/ | Published: 2026-11-03 | Updated: 2026-11-03

**The NE555 is a precision timer that runs from 4.5 to 16 V, can sink or source up to 200 mA at its output, and works as a one-shot (monostable) or a free-running oscillator (astable) set by a resistor and a capacitor.** It is still handy on a robot for a blinker, a buzzer tone, a simple PWM source or a delay that needs no code. Figures are from the Texas Instruments xx555 datasheet SLFS022K.

## Key specifications

| Supply (NE555) | 4.5–16 V |
| --- | --- |
| Output | sinks or sources up to 200 mA |
| Modes | astable or monostable |
| Trigger level | about 1/3 of supply |
| Threshold level | about 2/3 of supply |
| Packages | SOIC-8, PDIP-8 |

## What the datasheet promises

| Item | Datasheet value |
| --- | --- |
| Supply voltage (NE555) | 4.5 to 16 V |
| Output current | TTL-compatible output, sinks or sources up to 200 mA |
| Timing | Microseconds to hours |
| Modes | Astable or monostable, with adjustable duty cycle |
| Trigger level | About one third of the supply voltage |
| Threshold level | About two thirds of the supply voltage |
| Packages | 8-pin SOIC and PDIP, among others |

In the one-shot mode the interval is set by a single resistor and capacitor. In the free-running mode two resistors and one capacitor set the frequency and duty cycle independently. The reset pin overrides every other input, and the datasheet says to tie unused inputs to a proper logic level so they do not trigger falsely.

## Using it with a robot

- Power it from the same supply as the logic it drives, and add a bypass capacitor close to the supply pins.
- Keep the output current under 200 mA, and use a transistor or MOSFET for anything heavier.
- For motors, a microcontroller PWM pin with a driver such as the [TB6612FNG](https://roboticsengineering.in/components/tb6612fng-motor-driver/) is more flexible than a hardware timer.
- Use a CMOS version of the 555 if you need low supply current on a battery project.

For debounce or long timeouts in software, see the [debounce guide](https://roboticsengineering.in/fix/capacitive-touch-and-limit-switch-bounce-use-debounce-time/) and [millis instead of delay](https://roboticsengineering.in/fix/arduino-delay-blocks-robot-use-millis/).

## Sources and further reading

- [Texas Instruments xx555 precision timers datasheet (SLFS022K)](https://www.ti.com/lit/ds/symlink/ne555.pdf) — the supply range, output current, modes and trigger levels above.

Last reviewed: November 2026. Limits are from the Texas Instruments datasheet for the NE555; other makers and CMOS versions differ. No price is quoted because it has not been checked.
