# 74HC165 input shift register: read 8 inputs on 3 pins

> A parallel-load shift register that reads eight buttons or sensors over three pins: supply, clock speed, load control and chaining.

Canonical: https://roboticsengineering.in/components/sn74hc165-input-shift-register/ | Published: 2026-11-03 | Updated: 2026-11-03

**The 74HC165 is an 8-bit parallel-load shift register: eight inputs are captured at once and then clocked out as a single serial stream, so three microcontroller pins can read eight buttons, switches or sensors.** It is the input twin of the [74HC595](https://roboticsengineering.in/components/sn74hc595-shift-register/) output register. It runs from 2 to 6 V and draws at most 80 µA. Figures are from the Texas Instruments SNx4HC165 datasheet SCLS116H.

## Key specifications

| Function | 8-bit parallel-load shift register |
| --- | --- |
| Supply | 2–6 V |
| Supply current | 80 µA max |
| Clock | 31 MHz typ at 4.5 V |
| Outputs | QH and complement |
| Controls | SH/LD, CLK INH |

## What the datasheet promises

| Item | Datasheet value |
| --- | --- |
| Function | 8-bit parallel-load shift register, parallel-to-serial conversion |
| Supply voltage | 2 to 6 V |
| Supply current | 80 µA maximum |
| Output drive | ±4 mA at 5 V; drives up to 10 LSTTL loads |
| Propagation delay | 13 ns typical |
| Clock frequency | 31 MHz typical at 4.5 V |
| Outputs | Serial output QH and its complement |
| Inputs | Eight direct data inputs A to H; 1 µA maximum input current |
| Controls | Shift/load (SH/LD) and clock-inhibit (CLK INH) |

While SH/LD is low, the parallel inputs are loaded independently of the clock. When SH/LD goes high, each low-to-high clock edge moves the data one place toward QH. Read the first bit before the first clock pulse, since the A-to-H snapshot already sits at the output.

## Using it on a robot

- Add a pull-up or pull-down on each input so a button reads a defined level instead of floating.
- Debounce in software, as in [the debounce guide](https://roboticsengineering.in/fix/capacitive-touch-and-limit-switch-bounce-use-debounce-time/).
- Chain more than one chip through the serial input to read sixteen or more lines on the same three pins.
- Power it from the same voltage as the controller so the inputs and QH stay compatible.

## Sources and further reading

- [Texas Instruments SNx4HC165 datasheet (SCLS116H)](https://www.ti.com/lit/ds/symlink/sn74hc165.pdf) — every figure in the table above.

Last reviewed: November 2026. Limits are from the Texas Instruments datasheet; other makers’ versions differ. No price is quoted because it has not been checked.
