# 74HC595 shift register: 8 outputs from 3 pins

> An 8-bit serial-in, parallel-out shift register: supply, output drive, the two clocks and how to chain chips for more outputs.

Canonical: https://roboticsengineering.in/components/sn74hc595-shift-register/ | Published: 2026-11-03 | Updated: 2026-11-03

**The 74HC595 is an 8-bit serial-in, parallel-out shift register with a storage register and 3-state outputs: three microcontroller pins can drive eight outputs, and chips chain for more.** It runs from 2 to 6 V, gives about ±6 mA of output drive at 5 V and draws at most 80 µA. On a robot it adds LEDs, a segment display or relay-driver inputs when you run out of pins. Figures are from the Texas Instruments SNx4HC595 datasheet SCLS041J.

## Key specifications

| Function | 8-bit shift register with storage register |
| --- | --- |
| Supply | 2–6 V |
| Output drive | ±6 mA at 5 V |
| Supply current | 80 µA max |
| Propagation delay | 13 ns typ |
| Outputs | 3-state |

## What the datasheet promises

| Item | Datasheet value |
| --- | --- |
| Function | 8-bit serial-in, parallel-out shift register feeding an 8-bit storage register |
| Supply voltage | 2 to 6 V |
| Output drive | ±6 mA at 5 V; can drive up to 15 LSTTL loads |
| Supply current | 80 µA maximum |
| Propagation delay | 13 ns typical |
| Input current | 1 µA maximum |
| Clear | Direct overriding clear on the shift register (SRCLR) |
| Outputs | 3-state, high impedance when OE is high |
| Packages (SN74HC595) | PDIP, SOIC, SSOP and TSSOP, all 16 pin |

There are two clocks. The shift clock (SRCLK) moves bits in; the storage clock (RCLK) copies them to the outputs all at once, so the outputs do not flicker while you shift. A serial output pin carries the last bit on, which is how you chain a second chip.

## Using it on a robot

- Wire SER to a data pin, SRCLK and RCLK to two more, and tie SRCLR high and OE low for normal use.
- Keep each output within about 6 mA. For an LED that is a series resistor; for a relay or motor use a transistor or the [ULN2003A](https://roboticsengineering.in/components/uln2003a-darlington-driver/) between the output and the load.
- On a 3.3 V board, power the chip from 3.3 V so the outputs match the logic level.
- Check the total current across all eight outputs against the package limits in the datasheet before lighting eight LEDs at full brightness.

## Sources and further reading

- [Texas Instruments SNx4HC595 datasheet (SCLS041J)](https://www.ti.com/lit/ds/symlink/sn74hc595.pdf) — every figure in the table above.

Last reviewed: November 2026. Limits are from the Texas Instruments datasheet; other makers’ versions differ. No price is quoted because it has not been checked.
