# TCA6408A I2C I/O expander: 8 bits, 1.65 to 5.5 V, interrupt and reset

> An 8-bit I2C GPIO expander with separate bus and port supplies for level translation: voltage, speed, addresses, interrupt and packages.

Canonical: https://roboticsengineering.in/components/tca6408a-i2c-io-expander/ | Published: 2026-11-03 | Updated: 2026-11-03

**The TCA6408A is an 8-bit I2C and SMBus I/O expander with separate supplies from 1.65 V to 5.5 V on the bus side and the port side, so it also translates levels between a 1.8 V controller and 5 V peripherals.** It adds eight pins to a controller short of GPIO. It is a lower-voltage sibling of the [TCA9534](https://roboticsengineering.in/components/tca9534-i2c-io-expander/) and [PCF8574](https://roboticsengineering.in/components/pcf8574-io-expander/). Figures are from the Texas Instruments TCA6408A datasheet SCPS192E.

## Key specifications

| I/O | 8 bits |
| --- | --- |
| Supply | 1.65–5.5 V (VCCI and VCCP) |
| I2C | 100 kHz and 400 kHz |
| Addresses | 2 |
| Interrupt | open-drain INT |
| I/O tolerance | 5 V |
| Packages | TSSOP-16, VQFN-16, UQFN-16 |

## What the datasheet promises

| Item | Datasheet value |
| --- | --- |
| I/O | Eight general-purpose parallel I/O pins |
| Supply | 1.65 V to 5.5 V on both the I2C side (VCCI) and the port side (VCCP) |
| Level translation | Between 1.8 V, 2.5 V, 3.3 V and 5 V on the I2C bus and ports |
| Speed | 100 kHz standard and 400 kHz fast mode |
| Addresses | One address pin allows two devices on the same bus |
| Control | Active-low RESET input and open-drain active-low INT output |
| Registers | Input, output, polarity-inversion and configuration registers; powers up with all pins as inputs |
| I/O features | 5 V tolerant ports; latched outputs with high-current drive for LEDs; standby current 1 µA |
| Packages | TSSOP-16, VQFN-16 and UQFN-16 |

The interrupt output lets the controller skip polling: the pin goes low when an input changes, and the controller then reads the input register. The chip powers up with all channels as inputs and no glitch on power-up, so connected loads do not flicker at start.

## Using it on a robot

- Add buttons, limit switches and LEDs to a controller with few pins.
- Use the INT pin to react to a switch change without polling the bus.
- Run the bus side at 1.8 V or 3.3 V and the port side at 5 V to drive 5 V parts without a separate level shifter.

## Sources and further reading

- [Texas Instruments TCA6408A datasheet (SCPS192E)](https://www.ti.com/lit/ds/symlink/tca6408a.pdf) — I/O count, supply, level translation, speed, addresses, interrupt, registers and packages above.

Last reviewed: November 2026. Limits are from the Texas Instruments datasheet; breakout boards and modules vary. No price is quoted because it has not been checked.
