# TCA9534 I/O expander: 8 pins over I2C, 1.65 to 5.5 V

> An 8-bit I2C GPIO expander with interrupt output and eight addresses: supply, I/O tolerance and wiring notes from the TI datasheet.

Canonical: https://roboticsengineering.in/components/tca9534-i2c-io-expander/ | Published: 2026-11-03 | Updated: 2026-11-03

**The TCA9534 adds eight general-purpose input/output pins to a controller over two I2C wires, runs from 1.65 to 5.5 V and has 5 V-tolerant I/O, so it works with both 3.3 V and 5 V boards.** It is a newer-generation alternative to the [PCF8574](https://roboticsengineering.in/components/pcf8574-io-expander/), with configuration and polarity registers and an interrupt output. Figures are from the Texas Instruments TCA9534 datasheet SCPS197D.

## Key specifications

| I/O | 8 bits |
| --- | --- |
| Supply | 1.65–5.5 V |
| I/O tolerance | 5 V |
| I2C | 100 kHz and 400 kHz |
| Addresses | 8 (A0–A2) |
| Interrupt | open-drain, active low |
| Packages | TSSOP-16, SOIC-16 |

## What the datasheet promises

| Item | Datasheet value |
| --- | --- |
| Function | 8-bit I2C and SMBus I/O expander with configuration registers |
| Supply voltage | 1.65 to 5.5 V |
| I/O ports | 5 V tolerant |
| I2C speed | 100 kHz (Standard-mode) and 400 kHz (Fast-mode) |
| Addresses | Three hardware pins A0, A1, A2 allow up to eight devices on one bus |
| Interrupt | Open-drain, active-low INT output signals an input change |
| Registers | Input, output, polarity inversion and configuration |
| Power-up | All pins start as inputs, with no glitch on power-up |
| Packages | TSSOP-16 (5.00 × 4.40 mm) and SOIC-16 |

Use the interrupt line so the controller reads the chip only when an input changes, instead of polling it. The datasheet’s electrical tables give the sink and source limits for each pin; check them before you drive an LED directly.

## Using it on a robot

- Read buttons or limit switches on spare pins, and wire INT to a microcontroller interrupt pin.
- Because pins start as inputs on power-up, outputs that drive a relay or driver stay off until your code sets them.
- For a bank of eight inputs with no I2C, the [74HC165](https://roboticsengineering.in/components/sn74hc165-input-shift-register/) does a similar job over three pins.
- Add pull-up resistors on SDA and SCL, one set for the whole bus.

## Sources and further reading

- [Texas Instruments TCA9534 datasheet (SCPS197D)](https://www.ti.com/lit/ds/symlink/tca9534.pdf) — supply, tolerance, speed, addresses, interrupt and packages above.

Last reviewed: November 2026. Limits are from the Texas Instruments datasheet; breakout boards and modules vary. No price is quoted because it has not been checked.
