# TXS0108E level shifter: 8 channels, 1.4 to 5.5 V

> An 8-bit bidirectional level translator with no direction pin: supply ranges, data rates and what it is for between 3.3 V and 5 V parts.

Canonical: https://roboticsengineering.in/components/txs0108e-level-shifter/ | Published: 2026-11-03 | Updated: 2026-11-03

**The TXS0108E is an 8-bit bidirectional level translator that needs no direction pin: the A side runs from 1.4 to 3.6 V, the B side from 1.65 to 5.5 V, at up to 110 Mbps push-pull or 1.2 Mbps open-drain.** It is the board that lets a 3.3 V ESP32 or Raspberry Pi talk safely to 5 V parts. Figures are from the Texas Instruments TXS0108E datasheet SCES642L.

## Key specifications

| Channels | 8 bidirectional |
| --- | --- |
| VCCA | 1.4–3.6 V |
| VCCB | 1.65–5.5 V |
| Data rate | 110 Mbps push-pull, 1.2 Mbps open-drain |
| Direction pin | none |
| Output enable | OE |

## What the datasheet promises

| Item | Datasheet value |
| --- | --- |
| Channels | 8, bidirectional, non-inverting |
| A port supply (VCCA) | 1.4 to 3.6 V |
| B port supply (VCCB) | 1.65 to 5.5 V (VCCA must not exceed VCCB) |
| Translation nodes | Between 1.5 V, 1.8 V, 2.5 V, 3.3 V and 5 V |
| Data rate | 110 Mbps push-pull; 1.2 Mbps open-drain |
| Direction control | None needed |
| Output enable | Outputs go high-impedance when OE is low |
| Power sequencing | None required; either supply can come up first |
| ESD (B port) | ±8 kV contact discharge per IEC 61000-4-2 |
| Packages | TSSOP-20, VQFN-20 |

The 1.2 Mbps open-drain figure is the one to remember for I2C and one-wire lines, where the device must also handle pull-ups. For fast push-pull signals such as SPI or UART the 110 Mbps figure applies. Check the datasheet’s application section before using it on an I2C bus.

## Using it on a robot

- Power VCCA from the 3.3 V board and VCCB from the 5 V side, and share the ground.
- Tie OE high to enable the outputs, or hold it low through a pull-down to keep them off during power-up.
- Do not put heavy loads on the outputs; this is a signal translator, not a driver.

## Sources and further reading

- [Texas Instruments TXS0108E datasheet (SCES642L)](https://www.ti.com/lit/ds/symlink/txs0108e.pdf) — the supply ranges, data rates, enable behaviour and ESD figures above.

Last reviewed: November 2026. Limits are from the Texas Instruments datasheet; breakout boards vary. No price is quoted because it has not been checked.
