Actuator Selection & Torque-Speed Curve

BLDC vs Stepper vs Servo Motor Selector (FOC & Closed-Loop Sizing)

Enter load torque, speed, duty cycle, and feedback needs to size shaft power, bus amps, and plot your operating point on the live Torque-vs-RPM curve.

Recommended Motor + Drive
-
-
Sized Torque (1.5x Margin)
-
-
Mechanical Shaft Power
-
- HP
Est. Bus Current Draw
-
At selected bus voltage
Evaluating motor envelope...
Torque vs Speed Envelope (Normalized Curves + Your Operating Point)
AC Servo / Peak 3x Burst BLDC + FOC (Flat Torque to Base RPM) Stepper Pull-Out Dropoff 4000 RPM 0 RPM
Editorial Note: Bench-verified engineering reference published by RoboticsEngineering.in · An industrial technical publication by Jaadu Digital.Reviewed by Jignesh S Panchal

Frequently Asked Bench-Engineering Questions

Why does an open-loop stepper stall silently when a robot arm accelerates fast?

Stepper pull-out torque drops steeply above 400-800 RPM because coil inductance blocks current rise between full steps. Without an encoder, once rotor lag exceeds half a step (~0.9 deg on 1.8 deg steppers), magnetic torque reverses sign and the axis stalls without telling the PLC.

When is a closed-loop stepper (like CL57/TMC) better than a BLDC FOC actuator?

At low speed (< 400 RPM) and high static holding duty (Z-stages, leadscrew feeders, camera sliders), a high-pole-count closed-loop stepper delivers huge zero-speed torque without a gearbox and holds position quietly with encoder stall recovery.

Why do legged robots and cobots prefer BLDC motors with Field-Oriented Control (FOC)?

FOC decouples flux and torque-producing quadrature current Iq in real time at 10-25 kHz, letting a low-ratio planetary + BLDC actuator regulate pure compliant torque (backdrivable virtual springs) instead of stiff position-only control.

Do I need a braking resistor on a 48V BLDC or 230V servo bus?

Yes on vertical Z-axes or rapid deceleration of heavy arms. When a load overhauls the motor, kinetic energy regenerates back into the DC bus capacitors, tripping overvoltage faults (typically > 56V on 48V nominal buses) unless clamped by an external regen shunt resistor.

Interactive tool by RoboticsEngineering.in