TCA9548A I2C multiplexer: 8 channels, 1.65 to 5.5 V

An 8-channel I2C switch that fixes address clashes: supply, clock, level translation and the select-a-channel-first rule.

By Jignesh Panchal · Editorial & verification standards

  • TypeBoards
  • LevelIntermediate
  • ReviewedNov 2026

The TCA9548A is an 8-channel I2C switch: one upstream SDA/SCL pair fans out to eight downstream pairs, runs from 1.65 to 5.5 V and clocks up to 400 kHz. Its main job on a robot is to solve address clashes, for example eight identical sensors that all answer at the same address, by putting one on each channel. Figures are from the Texas Instruments TCA9548A datasheet SCPS207H.

Key specifications

Channels8
Supply1.65–5.5 V
Clockup to 400 kHz
Level translation1.8 / 2.5 / 3.3 / 5 V
Addresses3 pins, up to 8 devices
Resetactive-low RESET input

What the datasheet promises

ItemDatasheet value
Channels1-to-8 bidirectional translating switches
Supply voltage1.65 to 5.5 V
Clock frequency0 to 400 kHz
Level translationBetween 1.8 V, 2.5 V, 3.3 V and 5 V buses
Input tolerance5 V tolerant inputs
Channel selectionThrough the I2C bus, any combination of channels
AddressesThree address pins, up to eight devices on one bus
ResetActive-low RESET input; power-on reset deselects all channels
Power-upAll channels deselected, no glitch, supports hot insertion

Because every channel is off after power-up, nothing downstream is visible until you write the control register to select a channel. A common beginner symptom is a scanner that finds only the multiplexer itself: select a channel first, then scan.

Using it on a robot

  • Connect the controller to the upstream SDA and SCL, and each sensor to one SDn/SCn pair.
  • Write the channel bit before talking to a sensor, and select one channel at a time unless you want devices to share a bus segment.
  • Each downstream segment needs its own pull-up resistors when the breakout does not include them.
  • Wire RESET high, or to a controller pin, so you can free a stuck downstream bus without removing power.
  • Use the three address pins to run up to eight multiplexers on one bus, which gives many channels.

It pairs well with identical sensors such as several MPU6050 boards, which only have two selectable addresses. For servo outputs over I2C, see the PCA9685.

Sources and further reading

Last reviewed: November 2026. Limits are from the Texas Instruments datasheet; breakout boards vary. No price is quoted because it has not been checked.

Where to buy in India

These open a store search. Compare seller, price and reviews before you order.

Free: the final-year project pack

A shortlist with BOMs, a report outline that matches the usual chapter scheme, a costing sheet and 40 viva questions. Built for the February–April submission season.

The Build Note

One short email when something is worth your bench time.

A new build sheet, a part price that moved, or a mistake worth avoiding. No daily drip, no recycled news.

One short email when a build or a price is worth your time. Unsubscribe in one click.