BQ2407x Li-ion charger: 1.5 A with power path, 28 V input

A single-cell lithium charger with power-path management so the robot runs while charging: input rating, current, USB limits and variants.

By Jignesh Panchal · Editorial & verification standards

  • TypePower
  • LevelAdvanced
  • ReviewedNov 2026

The BQ2407x family (BQ24072 to BQ24079) are standalone single-cell lithium battery chargers with a 28 V input rating and overvoltage protection, charge current up to 1.5 A, and a power path that runs the robot while the battery charges. The power path means the load is supplied from the input first, so a half-charged battery is not cycled while the robot is plugged in. Figures are from the Texas Instruments BQ2407x datasheet SLUS810N.

Key specifications

Cells1
Input rating28 V with OVP
Charge currentup to 1.5 A
USB limits100 / 500 mA
Power pathDPPM
PackageVQFN-16

What the datasheet promises

ItemDatasheet value
Cell count1-cell linear charger
Input rating28 V, with overvoltage protection
Charge currentUp to 1.5 A, with a current-monitoring output (ISET)
Input current limitProgrammable up to 1.5 A for wall adapters; selectable 100 mA and 500 mA for USB
USB compliance100 mA maximum limit ensures USB-IF compliance
Power pathDynamic power-path management powers the system while independently charging the battery
Source protectionInput dynamic power management protects against poor USB sources
SafetyProgrammable pre-charge and fast-charge safety timers
VariantsSystem output tracks battery (BQ24072); programmable termination current (BQ24074); battery disconnect via SYSOFF (BQ24075, BQ24079)
PackageVQFN-16

It is a linear charger, so it burns the difference between the input and the battery voltage as heat. Charging a single cell at 1.5 A from a 5 V supply is workable; from a higher input the chip will reach thermal limits sooner.

Using it on a robot

  • Set the charge current with the resistor on ISET to the cell’s rating; do not exceed what the cell allows.
  • Use a protected cell, and read the chosen variant’s charge voltage in the datasheet before use.
  • Charge only with a supervised charger designed for lithium cells, and never leave a damaged pack charging.
  • For the downstream rail, a boost or buck-boost converter such as the TPS63020 holds a steady voltage as the cell discharges.
  • For a cell pack in a robot see the 18650 battery pack guide.

Sources and further reading

Last reviewed: November 2026. Limits are from the Texas Instruments datasheet; charger boards vary. No price is quoted because it has not been checked.

Where to buy in India

These open a store search. Compare seller, price and reviews before you order.

Free: the final-year project pack

A shortlist with BOMs, a report outline that matches the usual chapter scheme, a costing sheet and 40 viva questions. Built for the February–April submission season.

The Build Note

One short email when something is worth your bench time.

A new build sheet, a part price that moved, or a mistake worth avoiding. No daily drip, no recycled news.

One short email when a build or a price is worth your time. Unsubscribe in one click.